GNUCAP(1)
NAME
gnucap - GNU Circuit Analysis Package
SYNOPSIS
gnucap [-b filename] [-i filename]
DESCRIPTION
GNUCAP is a general purpose circuit simulator. It performs nonlinear
dc and transient analyses, fourier analysis, and ac analysis linearized
at an operating point. It is fully interactive and command driven. It
can also be run in batch mode or as a server. The output is produced
as it simulates. Spice compatible models for the MOSFET (level 1,2,3)
and diode are included in this release.
Since it is fully interactive, it is possible to make changes and resimulate quickly. The interactive design makes it well suited to the
typical iterative design process used it optimizing a circuit design.
It is also well suited to undergraduate teaching where Spice in batch
mode can be quite intimidating. This version, while still officially
in beta test, should be stable enough for basic undergraduate teaching
and courses in MOS design, but not for bipolar design.
In batch mode it is mostly Spice compatible, so it is often possible to
use the same file for both GNUCAP and Spice.
The analog simulation is based on traditional nodal analysis with iteration by Newton's method and LU decomposition. An event queue and
incremental matrix update speed up the solution for large circuits (at
some expense for small circuits).
It also has digital devices for mixed signal simulation. The digital
devices may be implemented as either analog subcircuits or as true digital models. The simulator will automatically determine which to use.
Networks of digital devices are simulated as digital, with no conversions to analog between gates. This results in digital circuits being
simulated faster than on a typical analog simulator, even with behavioral models. The digital mode is experimental and needs work. There
will be substantial improvements in future releases.
OPTIONS
Two command-line options are available. Only one of these may be specified. If no parameters are given, gnucap will start in interactive
mode.
- -b filename
- execute the commands in the named file then exit (batch mode)
- -i filename
- execute the commands in the named file then go into interactive mode
BUGS
See /usr/share/doc/gnucap/bugs for a list of known bugs in this
release.
GNUCAP is an ongoing research project. It is being released in a preliminary phase in hopes that it will be useful and that others will use
it as a thrust or base for their research. I also hope for some comments that may help me direct my research.
AUTHOR
GNUCAP is being written by Albert Davis <aldavis@ieee.org>
- This manual page was written by Jon Rabone <jkr@debian.org> and maintained by Hamish Moffatt <hamish@debian.org> for the Debian package of gnucap. For the full LaTeX documentation, please see /usr/share/doc/gnucap/manual.