MEASERL(1)

NAME

measerl - Measure the echo-return loss on Voicetronix telephony hardware

SYNOPSIS

measerl [options]

DESCRIPTION

The measerl utility tests the echo-return loss on the phone line. For hardware that supports it, it can scan through bybrid balance register settings to help establish a lower ERL. Having a lower ERL improves DTMF cutthrough and audio quality. The software echo cancellation needs at least -6dB before it can make a difference.

FXS (station) ports should perform this test using the --nohook option with the handset already off hook and the microphone muted.

FXO (trunk) ports will answer to an incoming call.

A series of tones will be played down the line to determine the ERL in several parts of the audio spectrum. You should avoid creating any other noise on the line while this test is running, or the results may be skewed.

OPTIONS

The following options are available:

--help, -?

Show summary of options.

--card number

Explicitly select the card to test. Default is card 0.

--port number

Explicitly select the port to test. Default is port 0 of the card being tested.

--nohook

Use this option for testing station (FXS) ports.

--offhook

Take an FXO port off hook immediately. Don't wait for an incoming ring.

--bal1 value

--bal2 value

--bal3 value

Set codec hybrid balance registers. Only for hardware which explicitly supports that.

--ec Enable the echo canceller.

--pg gain

Set codec play gain. Values may range from -12.0 to 12.0.

--rg gain

Set codec record gain. Values may range from -12.0 to 12.0.

--dial port

Dial out another port on the same card.

--dial port number

Dial number from port on the same card.

--scan file start end step

Scan the hybrid balance register settings from start to end in increments of step, recording the results to file. Only for hardware that explicitly permits setting these registers. Valid values for the start and end are in the range 0 - 255.

--autoscan

Automatically scan the codec balance values.

--handset

Proto handset mode.

--loop Enable software loopback.

--hostecho

Enable the host based echo canceller.

SEE ALSO

vpbecho(1), ringstat(1)

AUTHOR

Ron Lee, Peter Wintulich, David Rowe, Voicetronix <support@voicetronix.com.au>

This manual page was written by Ron <ron@debian.org>, for the Debian project (but may be used by others).

VPB driver package Jan 4, 2007 MEASERL(1)