shorewall-providers(5)
NAME
providers - Shorewall Providers file
SYNOPSIS
/etc/shorewall/providers
DESCRIPTION
This file is used to define additional routing tables. You will want to
define an additional table if:
- o You have connections to more than one ISP or multiple connections
- to the same ISP
- o You run Squid as a transparent proxy on a host other than the
- firewall.
- o You have other requirements for policy routing.
- Each entry in the file defines a single routing table.
- If you wish to omit a column entry but want to include an entry in the next column, use "-" for the omitted entry.
- The columns in the file are as follows.
- NAME - name
- The provider name. Must be a valid shell variable name. The names 'local', 'main', 'default' and 'unspec' are reserved and may not be used as provider names.
- NUMBER - number
- The provider number -- a number between 1 and 15. Each provider
must be assigned a unique value. - MARK - value
- A FWMARK value used in your shorewall-tcrules[1](5) file to direct packets to this provider.
- If HIGH_ROUTE_MARKS=Yes in shorewall.conf[2](5), then the value
must be a multiple of 256 between 256 and 65280 or their
hexadecimal equivalents (0x0100 and 0xff00 with the low-order byte of the value being zero). Otherwise, the value must be between 1
and 255. Each provider must be assigned a unique mark value. - DUPLICATE - routing-table-name
- The name of an existing table to duplicate to create this routing
table. May be main or the name of a previously listed provider. You may select only certain entries from the table to copy by using the COPY column below. - INTERFACE - interface
- The name of the network interface to the provider. Must be listed
in shorewall-interfaces[3](5). - GATEWAY - {-|address|detect}
- The IP address of the provider's gateway router.
- You can enter "detect" here and Shorewall will attempt to detect
the gateway automatically. - For PPP devices, you may omit this column.
- OPTIONS (Optional) - [-|option[,option]...]
- A comma-separated list selected from the following. The order of
the options is not significant but the list may contain no embedded whitespace. - track
If specified, inbound connections on this interface are to be
tracked so that responses may be routed back out this same
interface.You want to specify track if internet hosts will be connecting to local servers through this provider. - balance[=weight]
The providers that have balance specified will get outbound traffic load-balanced among them. By default, all interfaces
with balance specified will have the same weight (1). You can change the weight of an interface by specifiying balance=weight where weight is the weight of the route out of this interface. - loose
Shorewall normally adds a routing rule for each IP address on
an interface which forces traffic whose source is that IP
address to be sent using the routing table for that interface. Setting loose prevents creation of such rules on this interface. - optional
If the interface named in the INTERFACE column is not up and
configured with an IPv4 address then ignore this provider. - COPY - [{none|interface[,interface]...}]
- A comma-separated list of other interfaces on your firewall.
Wildcards specified using an asterisk ("*") are permitted (e.g.,
tun* ). Usually used only when DUPLICATE is main. Only copy routes through INTERFACE and through interfaces listed here. If you only
wish to copy routes through INTERFACE, enter none in this column.
EXAMPLES
- Example 1:
- You run squid in your DMZ on IP address 192.168.2.99. Your DMZ
interface is eth2
#NAME NUMBER MARK DUPLICATE INTERFACE GATEWAY OPTIONS Squid 1 1 - eth2 192.168.2.99 - Example 2:
- eth0 connects to ISP 1. The IP address of eth0 is 206.124.146.176
and the ISP's gateway router has IP address 206.124.146.254. - eth1 connects to ISP 2. The IP address of eth1 is 130.252.99.27 and the ISP's gateway router has IP address 130.252.99.254.
- eth2 connects to a local network.
#NAME NUMBER MARK DUPLICATE INTERFACE GATEWAY OPTIONS COPY ISP1 1 1 main eth0 206.124.146.254 track,balance eth2 ISP2 2 2 main eth1 130.252.99.254 track,balance eth2
FILES
/etc/shorewall/providers
SEE ALSO
http://shorewall.net/MultiISP.html
shorewall(8), shorewall-accounting(5), shorewall-actions(5),
shorewall-blacklist(5), shorewall-hosts(5), shorewall-interfaces(5),
shorewall-ipsec(5), shorewall-maclist(5), shorewall-masq(5),
shorewall-nat(5), shorewall-netmap(5), shorewall-params(5),
shorewall-policy(5), shorewall-proxyarp(5), shorewall-route_routes(5),
shorewall-routestopped(5), shorewall-rules(5), shorewall.conf(5),
shorewall-tcclasses(5), shorewall-tcdevices(5), shorewall-tcrules(5),
shorewall-tos(5), shorewall-tunnels(5), shorewall-zones(5)
NOTES
- 1. shorewall-tcrules
- shorewall-tcrules.html
- 2. shorewall.conf
shorewall.conf.html - 3. shorewall-interfaces
shorewall-interfaces.html